1 | Front half of propeller shaft |
2 | Rear half of propeller shaft |
4 | Sealing bellows |
7b | Elastomer bearing |
8 | Deep-groove ball bearing |
P41.10-2002-11
Notes on safety-relevant components | |||
| Remove | ||
1 | Remove propeller shaft |
| |
Model 205, 213, 238 | |||
2 | Detach front half of propeller shaft (1) and rear half of propeller shaft (2) from slide joint connection | ||
3 | Pull seal bellows (4) off front half of propeller shaft (1) | ||
4 | Detach elastomer bearing (7b) together with grooved ball bearing (8) from rear half of propeller shaft (2) | ||
Puller arms | |||
Puller, two-arm | |||
5 | Press grooved ball bearing (8) out of elastomer bearing (7b) |
| |
Model 205, 253 (except 253.992/993) | |||
Removal and installation tool | |||
| Install | ||
6 | Press grooved ball bearing (8) into elastomer bearing (7b) |
| |
Model 205, 253 (except 253.992/993) | |||
Removal and installation tool | |||
7 | Press elastomer bearing (7b) together with grooved ball bearing (8) onto joint fork of rear half of propeller shaft (2) | ||
Drift | |||
8 | Check seal bellows (4) for damage and leakages | If damaged or leaking | |
| |||
Replace axle boots (4). | |||
9 | Fit seal bellows (4) onto front half of propeller shaft (1) | Check for correct seating. | |
10 | Press front and rear halves of propeller shaft (1, 2) together | ||
Long-life grease | |||
11 | Install propeller shaft |
| |
Model 205, 213, 238 |
129 589 00 34 00
Puller arms
126 589 03 15 00
Drift
000 589 88 33 00
Puller, two-arm
116 589 09 43 00
Removal and installation tool
Henviste dokumenter
- ah0000z001901a Oplysninger om sikkerhedsrelevante komponenter
- ar4110p005005lw
- ar4110p0050lw
- ar4110p0050lw
- ar4110p0050lwx
- ar4110p0050lwx
- ar4110p010002lw
- ar4110p010003olc
- ar4110p010005lw
- ar4110p010007lw