Measure absolute angle at the front and rear of the rear propeller shaft

AR41.10-P-0085-10MSC

Measure absolute angle at the front and rear of the rear propeller shaft



000 588 14 19 00 Inclinometer adapter

WS26.00-P-0234B

Model

167

1

Clean contact surface for  adapter for transmission  (021) at front of rear propeller shaft  (4).

021

Adapter for transmission

021a

Spirit level

086a

Measuring sensor

086b

Measuring sensor connecting cable

4

Front of rear propeller shaft

2

 Position  adapter for transmission  (021) at front of rear propeller shaft  (4) (magnetic).

3

 Align  adapter for transmission  (021) horizontally in transverse direction using spirit level  (021a).

4

Place measuring sensor  (086a) on support plate of   adapter for transmission  (021).

 For each measurement, the connecting cable  (086b) must point in the direction of travel, otherwise the measurement will be incorrect. Ensure that the measuring sensor  (086a) is seated correctly in the bores of the support plate, otherwise the measurement will be incorrect. If the measuring sensor  (086a) is not positioned horizontally, a fault message appears. The measured angle cannot be read out or stored.

5.1

If the electronic inclinometer is used or if measurement is performed using the electronic propeller shaft inclinometer in inclination measuring mode, only the absolute angle will be measured. The articulation angle must be calculated using a data sheet. The measured value must not be stored.
Read out absolute angle at front of rear propeller shaft  (4) from display and enter into data sheet.

5.2

If the electronic propeller shaft inclinometer with memory extension is used or the electronic inclination-propeller shaft inclinometer with memory extension is used in articulation angle measuring mode.
Store absolute angle at front of rear propeller shaft  (4) in measuring instrument. To do so, press SAVE button.

 A confirmation message appears briefly. Indication of measurement readiness for the next angle then appears.

6

Clean contact surface of adapter for transmission  (021) at rear of rear propeller shaft  (5).

7

Position adapter for transmission  (021) at rear of rear propeller shaft  (5) (magnetic).

8

Unfasten heat shield  (7).

021

Adapter for transmission

021a

Spirit level

086a

Measuring sensor

086b

Measuring sensor connecting cable

5

Rear of rear propeller shaft

7

Heat shield

9

Align adapter for transmission  (021) horizontally in transverse direction using spirit level  (021a).

10

Place measuring sensor  (086a) on support plate of adapter for transmission  (021).

 For each measurement, the connecting cable  (086b) must point in the direction of travel, otherwise the measurement will be incorrect. Ensure that the measuring sensor  (086a) is seated correctly in the bores of the support plate, otherwise the measurement will be incorrect. If the measuring sensor  (086a) is not positioned horizontally, a fault message appears. The measured angle cannot be read out or stored.

11.1

If the electronic inclinometer is used or if measurement is performed using the electronic propeller shaft inclinometer in inclination measuring mode, only the absolute angle will be measured. The articulation angle must be calculated using a data sheet. The measured value must not be stored.
Read out absolute angle at rear of rear propeller shaft  (5) from display and enter into data sheet.

11.2

If the electronic propeller shaft inclinometer with memory extension is used or the electronic inclination-propeller shaft inclinometer with memory extension is used in articulation angle measuring mode.
Store absolute angle at rear of rear propeller shaft  (5) in measuring instrument. To do so, press SAVE button.

 A confirmation message appears briefly. Indication of measurement readiness for the next angle then appears.