Electronic inclination / propeller shaft articulation angle meter
1 | Press the STEP button. |
Articulation angle measurement is selected. |
Display message menu |
P41.10-2070-01
2 | Press STEP button while main menu is displayed. |
Measurement is selected. |
The measurement of all angles should be carried out without interruption. An angle that has already been measured can be measured a second time if required. To do so, with the Measurement menu displayed, press the STEP button repeatedly until the display indicates Ready to measure the relevant angle. |
Display message main menu |
P41.10-2071-01
Example illustration
3 | Clean mounting hole and surrounding area in transmission housing. |
4 | Select suitable measuring sleeve mount (020e) for mounting hole. |
5 | Insert measuring sleeve mount (020e) into mounting hole. |
6 | Turn threaded pin (020f) to left and tighten. |
P41.10-2441-01
7 | Screw measuring sleeve (020g) onto measuring sleeve mount (020e) and tighten all the way up to underside of transmission by hand. |
The entire contact surface of the measuring sleeve (020g) must lie flat against the underside of transmission. |
Example illustration |
P41.10-2442-01
8 | Attach sensor holder (020c) with both screws centrally on sensor (020a). |
P41.10-2064-01
9 | Fit sensor (020a) with magnetic sensor mount (020c) on measuring sleeve (020g) by turning slightly. |
When each measurement is taken, the side of the sensor (020a) at which the spiral cable (020b) is connected must point in the direction of travel. |
The device is ready to take a measurement and the measured values are shown in the display. |
Example illustration |
P41.10-2443-01
10 | Press SAVE button. |
The values are saved. |
Measurement values on display message for angle piece 1: Display, e.g. 1.92° |
P41.10-2075-01
A confirmation message appears briefly.
Display message confirmation |
P41.10-2076-01
The display then indicates that the device is ready for the next measurement (angle 2).
P41.10-2077-01
11 | Remove sensor (020a) and sensor holder (020c) from measuring sleeve (020g). |
12 | Remove sensor holder (020c) from sensor (020a). |
13 | Unscrew measuring sleeve (020g) from measuring sleeve mount (020e). |
Example illustration |
P41.10-2443-01
14 | Release threaded pin (020f) and remove measuring sleeve mount (020e) from mounting hole. |
Example illustration |
P41.10-2441-01
Henviste dokumenter
- ah4110p000201lf Oplysninger om måling af kardanaksel-knækvinkel