Remove/install propeller shaft intermediate bearing

AR41.10-D-0101I

17.6.11

MODEL 900, 906
Propeller shaft intermediate bearing (without protective caps) on sliding piece with 2- and 3-piece propeller shaft

D41.10-1121-06

1 Rear propeller shaft

2 Clamp

3 Rubber boot

4 Clamp

5 Protective cap

6 Propeller shaft intermediate bearing

7 Protective cap

8 Front propeller shaft

9 Shim (5 mm)

	Remove
1	Remove rear propeller shaft (1)		AR41.10-D-0050H
2	Remove rubber boot (3)		AR41.10-D-0101-01A
3	Detach propeller shaft intermediate bearing (6) with protective caps (5, 7)		AR41.10-D-0101-02A
		 Puller	*000589453300
		 Drift	*366589021500
4	Check all parts for wear and damage	 Replace parts if necessary.
	Install
5	Press on propeller shaft intermediate bearing (6) with protective caps (5, 7)	 If a propeller shaft intermediate bearing (6) with shim (9) is removed, a propeller shaft intermediate bearing (6) with shim (9) must also be installed. If this is not observed humming, droning and starting noise may be heard.	AR41.10-D-0101-03I
		 Drift	*906589011500
6	Install new rubber boots (3)	 Ensure that rubber boot (3) is seated properly.	AR41.10-D-0101-01A
		MB multipurpose grease	*BR00.45-Z-1017-06A
7	Install rear propeller shaft (1)		AR41.10-D-0050H

000 589 45 33 00

366 589 02 15 00

Drift

Puller

906 589 01 15 00

Drift

Repair materials

Number	Designation	Order number
BR00.45-Z-1017-06A	MB multipurpose grease	A 001 989 34 51 11