906 589 00 15 00
Drift
Drift
Drift
711 589 01 15 00
906 589 02 15 00
D41.10-1132-01
Perform following operation step only for propeller shaft intermediate bearing version with protective caps (4).
1 Drive protective cap (4) using drift onto flange (3).
Use drift 906 589 00 15 00.
Note installation position of protective cap (4).
D41.40-0005-01
2 Press on propeller shaft intermediate bearing (2 ) flush with flange (3) using drift.
Use drift 711 589 01 15 00.
To avoid damage, place wood or plastic under flange (3). Make sure when removing a propeller shaft intermediate bearing with shim (5) that the new propeller shaft intermediate bearing is also installed with a shim (5). If this is not observed humming, droning and starting noise may be heard.
D41.40-0008-01
3 Transfer punch mark (arrow) from old flange (3) to new flange (9).
Only perform this operation step if the flange (3) is to be replaced with a new one. Note position of flange (3) because the punch mark is used for the marriage of the propeller shaft and flange (9) and to facilitate installation.
D41.40-0006-01
Perform the following two operation steps only for the propeller shaft intermediate bearing version with protective caps (6) and if the protective cap (6) was removed.
4 Clamp propeller shaft (7) onto rigid part of universal joint in vise.
5 Drive protective cap (6) using drift up to end stop on propeller shaft (7).
Use drift 906 589 02 15 00.
Note installation position of protective cap (6).