086 | Inclinometer |
086a | Measuring sensor |
P40.20-0318-01
Illustration shows measuring point 2 at right front cross strut, model 204.0 without 4MATIC |
086a | Measuring sensor |
086b | Measuring sensor connecting cable |
17 | Cross strut |
P40.20-2273-02
Illustration shows measuring point 4 at right rear axle shaft, model 204.0 without 4MATIC |
086a | Measuring sensor |
086b | Measuring sensor connecting cable |
65 | Rear axle shaft |
P40.20-2274-01
| Check | ||
1 | Carry out preconditions and tests for vehicle level measurement | ||
2 | Clean measuring points | This prevents any measuring errors. | |
3 | Mount measuring sensor (086a) on cross strut (17) and read off vehicle level on inclinometer (086) | The connecting cable (086b) from the measuring sensor (086a) must point to the vehicle center otherwise an erroneous measurement takes place. | |
Mount the measuring sensor (086a) between the cast-in humps (arrows). If there are no humps present (arrows), mount measuring sensor (086a) in the center on the cross strut (17). | |||
Measure the vehicle level at | |||
Model 212Vehicle level - front axle | |||
MODEL 218Vehicle level - front axle | |||
4 | Mount the measuring sensor (086a) on rear axle shaft (65) and read off vehicle level on the inclinometer (086) | The connecting cable (086b) from the measuring sensor (086a) must point to the vehicle center otherwise an erroneous measurement takes place. | |
Measure the vehicle level at | |||
Model 212Vehicle level - rear axle | |||
MODEL 218Vehicle level - rear axle | |||
5 | Check the maximum permissible difference in vehicle level between the left and right side of the vehicle | The specified test tolerance applies only when checking the vehicle level but not for calibration. | |
If the vehicle level at the front or rear axle is out of tolerance, the springs and spring-rubber bushing must be checked for signs of wear and damage. | |||
Permissible difference in vehicle level at front axle between right and left sides of the vehicle | |||
| |||
Model 212Permissible difference in vehicle level between right and left side of vehicle | |||
MODEL 218Permissible difference in vehicle level between right and left side of vehicle | |||
Permissible difference in vehicle level at rear axle between right and left sides of the vehicle | |||
| |||
Model 212Permissible difference in vehicle level between right and left side of vehicle | |||
MODEL 218Permissible difference in vehicle level between right and left side of vehicle | |||
6 | Adjust headlamps | Only if the vehicle level was adjusted. | |
| Check and correct the adjustment of the headlamps |
Henviste dokumenter
- ap8210p8260ew Kontrol, korrektion af forlygteindstilling
- ar4000p0202a
- ar4000p0202a