Balancing wheels

AR40.10-P-1040CW

Balancing wheels

7.2.07

Balancing

1

Remove wheels



Remove/install wheels

AP40.10-P-4050CW

2.1

Remove jammed wheel balance weight (43a) using assembly tool



*124589176300

2.2

Remove adhesive weights (43b, 43c) using removal tool

 Do not use a hard, pointed or sharp-edged tool, in order to avoid damaging the surface of the disk wheels.



*129589005900

Loctite 7200

*BR00.45-Z-1038-04A



Clean

3

Clean wheels if necessary.

 Dirt on the tire or disk wheel cause incorrect measurement results when balancing and it is therefore essential that dirt be removed beforebalancing

Balance wheels while stationary

4

Mounting centering sleeve

AR40.10-P-1040-01A

5

Fasten wheels to stationary balancing machine and balance them

 Pay attention to manufacturer's operating instructions.

 Use adhesive weights (43b, 43c) when installation conditions are cramped. The residual imbalance may be a maximum of 10 g for each side of the wheel.

6

Mount wheels



Remove/install wheels

AP40.10-P-4050CW

Balance wheels dynamically

7

Switch off Electronic Stability Program (ESP)

 Press the ESP button (S6/1s5) in the instrument panel switch group (S6/1). The Electronic Stability Program warning lamp (A1e41) in the instrument cluster (A1) must light up.

8

Close vehicle doors, hood and trunk lid

 Danger!

Risk of death caused by being drawn into rotating vehicle parts

Do not insert your hand into rotating parts.
Wear closed and snug-fitting work clothes.
Secure area of rotating vehicle components against unauthorized access.

AS00.00-Z-0004-01A

9

Balance wheels with dynamic balancing machine on vehicle

 Drive rear wheels using vehicle engine only, as otherwise the rear axle center assembly will be damaged.

 Pay attention to manufacturer's operating instructions.
Only wheels which have been balanced statically beforehand may be dynamically balanced.

10

Switch on Electronic Stability Program ESP

 Press the ESP button (S6/1s5) in the instrument panel switch group (S6/1). The Electronic Stability Program warning lamp (A1e41) in the instrument cluster

(A1) must go out.

Number

Designation

Order number

BR00.45-Z-1038-04A

Loctite 7200

Henkel Loctite Deutschland GmbH
Arabellastrasse 17
81925 München
Germany
Tel. +49-899268-0
Fax +49-899101978
www.Loctite.de