ar3550w0110a

Removing, installing hydraulic pump

Type ar · emne 35.50 · version 0101 · 2012-02-21

Gælder for: REAR AXLE 749.011 with CODE (AN6) Twin-tired trailing axle (Nummek)

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 2 Chassis › 35 Bagaksel › 35.50 Ekstra aksler (forløbs-/efterløbs-/midter-/anhængeraksel)

EinPAS 17 Drivstreng/aksel › 17.52 Ekstra aksel › 17.52.32 Hydraulikpumpe/beholder

Gælder også for motorer/gearkasser: 749 011

AR35.50-W-0110A

Removing, installing hydraulic pump

15.2.12

REAR AXLE 749.011 with CODE (AN6) Twin-tired trailing axle (Nummek)

Removing, installing hydraulic pump

W35.50-1061-09

1 Lift solenoid valve connector

2 Lower solenoid valve connector

3 Hydraulic line

9 Fuse

10 Fuse connecting cable

11 Plug connector for pressure switch

12 Hydraulic pump

4 Ground cable

5 Positive cable

6 Hydraulic pump relay control line

7 Hydraulic pump relay positive connection

8 Fuse connecting cable

Removing, installing

1

Lower trailing axle

Danger!

Risk of explosion caused by escaping oxyhydrogen gas. Risk of injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte (contains diluted sulfuric acid) or metal spatter due to short circuit. Risk of burn injuries caused by short circuit. Risk of poisoning caused by swallowing battery electrolyte (contains diluted sulfuric acid) or absorption of lead over the skin or orifices

No fire, sparks, open flames or smoking.

Wear acid-resistant gloves and clothing and safety glasses with side guards.

Do not place any conductive objects on the battery and avoid any short circuit from battery positive to ground.

Only fill liquid battery electrolyte (diluted sulfuric acid) into suitable and appropriately marked containers.

AS54.10-Z-0001-01A

2

Disconnect ground lead from battery

Label all connectors

3

Disconnect connector (1) at lift solenoid valve

4

Disconnect connector (2) at lower solenoid valve

5

Disconnect hydraulic lines (3)

6

Remove ground cables (4) at hydraulic pump (12)

7

Disconnect positive cables (7) at hydraulic pump (12)

8

Remove relay control line (8) and relay positive connection (9) at hydraulic pump

9

Disconnect connecting cables (10 and 12) from fuse (11)

10

Disconnect connector (13) to pressure switch

11

Unscrew nuts at hydraulic pump (12) and lift out hydraulic pump

12

Install in the reverse order

13

Check oil level, hydraulic fluid

Henviste dokumenter