116 589 15 15 00
Drift
Press off joint hub
1 | Press off joint hub (37d) with half shells and drift (37a) from rear axle shaft. |
2 | Check splined profile on joint hub (37d) and rear axle shaft for damage. |
The joint hub (37d) can be used again if on its splined profile (arrow) no more than 3 teeth per caulking have broken out, up to a maximum length of 6 mm. |
P35.30-2032-02
Press on joint hub
3 | Clamp rear axle shaft using protective jaws into vise. |
4 | Press on joint hub (37d) using suitable tool until dimension (b) is reached. |
b | 4.2 mm |
P35.30-2035-01
Caulk joint hub
5 | Clamp rear axle shaft in vise so that the joint hub (37d) is resting on the half shells and the ball retainer can still be rotated. |
6 | Mount new caulkings (arrows) using caulker in the center between the caukings already there. |
P35.30-2036-01
The caulkings (arrow) must be made as close as possible to the splined profile.
This will prevent damage (e.g. breaking off) of the ball raceways.
P35.30-2124-01