Adjust preload of tapered roller bearings

Type ar · emne 35.30 · version 0101 · 2019-02-15

Gælder for: Rear axle 746.27/97 in model 382.171/177/180/181/185/188/189 Rear axle 746.960 Rear axle 746.961/964 in model 693.184/191/195, 695.043 Rear axle 746.962 in model 386.014 Rear axle 746.964 in model 693.144 Rear axle 746.966 in model 693.128, 695.014 Rear axle 746.974 in model 634.081 Rear axle 772 in model 695.302

Ikke tilgængelig på “da”; vises på Engelsk.

AR35.30-B-4302-01A

Rear axle	746.27/97 in model 382.171/177/180/181/185/188/189
Rear axle	746.960
Rear axle	746.961/964 in model 693.184/191/195, 695.043
Rear axle	746.962 in model 386.014
Rear axle	746.964 in model 693.144
Rear axle	746.966 in model 693.128, 695.014
Rear axle	746.974 in model 634.081
Rear axle	772 in model 695.302

055 589 05 21 00

Adjusting device

1	Gradually tighten the ring (1) just enough to clear the gap between the sprocket and pinion teeth. Then loosen it from 3 to 4 castles.

 Make sure that one of the ring holes (1) is aligned with the locking pin of the locking plate.

B35.30-0051-01

2	Gradually tighten the ring (2) using the pin wrench (3) until the clearance of the bearings is eliminated. From this point tighten it more, to get the necessary preload.  For NEW bearings = tighten from 2 to 3 castles. For USED bearings = tighten from 1 to 2 castles.

B35.30-0052-01