ar3530b430101xb

Detach tapered roller bearings from differential case

Type ar · emne 35.30 · version 0202 · 2020-02-04

Gælder for: Rear axle 742.824, 743.457, 746.881/882 in model 368.0/1, 384.2/3 Rear axle 742.825 in model 368.0/1, 384.3 Rear axle 746.270 in model 382.1, 634.0 Rear axle 746.271 in model 382.1, 634.0 Rear axle 746.888 in model 368 Rear axle 746.984 in model 384 Rear axle 746.987/988/996/998 in model 958.1 Rear axle 746.999 in model 384.067

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 2 Chassis › 35 Bagaksel › 35.30 Drev, drivaksler — Serie 368 · Serie 382 (modeller 1**) · Serie 384 · Serie 634 (modeller 0**) · Serie 958 (modeller 1**)

EinPAS 17 Drivstreng/aksel › 17.51 Bagaksel › 17.51.65 differentiale/akselkraftgennemføring — Serie 368 · Serie 382 (modeller 1**) · Serie 384 · Serie 634 (modeller 0**) · Serie 958 (modeller 1**)

Gælder også for motorer/gearkasser: 742 824, 742 825, 743 457, 746 270, 746 271, 746 881, 746 882, 746 888, 746 984, 746 987, 746 988, 746 996, 746 998, 746 999

AR35.30-B-4301-01XB

Detach tapered roller bearings from differential case

Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Rear axle

742.824, 743.457, 746.881/882 in model 368.0/1, 384.2/3

Rear axle

742.825 in model 368.0/1, 384.3

Rear axle

746.270 in model 382.1, 634.0

Rear axle

746.271 in model 382.1, 634.0

Rear axle

746.888 in model 368

Rear axle

746.984 in model 384

Rear axle

746.987/988/996/998 in model 958.1

Rear axle

746.999 in model 384.067

Detach tapered roller bearings from differential case
Detach tapered roller bearings from differential case
Detach tapered roller bearings from differential case

000 589 89 33 00

Puller

360 589 02 63 00

Thrust piece

327 589 00 63 00

Thrust piece

Detach tapered roller bearings from differential case

The differential and ring gear taper roller bearings should always be replaced as a set.
Remove

1

Install the buffer on the differential housing (2).


Only one of the two sides of the buffer fits in the differential.



2

Install the puller claws by the underside of the taper roller bearing cage (1).



3

Support the puller over the buffer and pull the taper roller bearing (1) out of the differential housing (2).


B35.31-0013-02