ar3530b430001b
Pull tapered roller bearing off drive pinion, press on
Type ar · emne 35.30 · version 0201 · 2020-07-07
Gælder for: Rear axle 743.451/453/454/458/480 in model 979.0
Ikke tilgængelig på “da”; vises på Engelsk.
Placering
Funktionsgruppe 2 Chassis › 35 Bagaksel › 35.30 Drev, drivaksler — Serie 979 (modeller 0**)
EinPAS 17 Drivstreng/aksel › 17.51 Bagaksel › 17.51.65 differentiale/akselkraftgennemføring — Serie 979 (modeller 0**)
Gælder også for motorer/gearkasser: 743 451, 743 453, 743 454, 743 458, 743 480
AR35.30-B-4300-01B
| Pull tapered roller bearing off drive pinion, press on
| 743.451/453/454/458/480
|
|
Rear axle
| 743.451/453/454/458/480 in model 979.0
|
1
| Install the extraction plate (3) on the pinion shaft (1) base, so that it supports the bearing from below
|
2
| Remove the bearing using a press
|
|
| Install the flange nut (2) on the pinion (1). The nut prevents the pinion from falling when removing the bearing.
|
3
| Heat the bearing to a temperature of approximately 80 °C
|
4
| Install the bearing (4) onto the pinion shaft (1)
|
|
| Observe the correct seating of the bearing.
|
|
| Work with a protective sleeve when inserting the hot bearing in the pinion shaft.
|
