Determining installed dimension of differential assembly

Type ar · emne 35.30 · version 0202 · 2020-02-04

Gælder for: Rear axle 742.825, 746.888 in model 368.0/1, 384.3 Rear axle 746.270/271 in model 382.1, 634.0 Rear axle 746.881/882 Rear axle 746.984 in model 384.0 Rear axle 746.987/988/996/998 in model 958.0/1 Rear axle 746.999 in model 384.067 #D

Ikke tilgængelig på “da”; vises på Engelsk.

AR35.30-B-0475-01XB

Rear axle	742.825, 746.888 in model 368.0/1, 384.3
Rear axle	746.270/271 in model 382.1, 634.0
Rear axle	746.881/882
Rear axle	746.984 in model 384.0
Rear axle	746.987/988/996/998 in model 958.0/1
Rear axle	746.999 in model 384.067 #D

001 589 53 21 00

Dial gage

055 589 01 23 00

Template

055 589 10 21 00

Adjusting device

1	Install the (  ) jig (1) on the (  ) adjusting device (2).

 Observe the correct seating of the supports of the  jig (1) on the surface of the  adjusting device (2), as well as the seating of the supports (4) on the ledge of the  jig (1).

2	Install the  dial gauges (3) on the  adjusting device (2), and support their contact points on the ledge of the  jig (1)

 Set a load of approximately 2 mm on pointer (5) and adjust on zero the pointers (6) of the  dial gauges (3).

B35.31-0033-11