1 | Tapered roller bearing |
2 | Ring gear |
3 | Stop washer |
4 | Planetary gear |
5 | Pressure washer |
6 | Differential side gear |
7 | Split shaft of the spider |
8 | Full shaft of the spider |
9 | Planetary gear |
10 | Stop washer |
11 | Satellite box housing |
12 | Tapered roller bearing |
13 | Bolt |
B35.30-0114-06
| Disassemble | ||
1 | Remove the rear axle differential |
| |
Puller | |||
2 | Remove the tapered roller bearings (12) from the satellite box housing | Thrust piece | |
Thrust element | |||
Puller | |||
3 | Remove the tapered roller bearing (1) from the crown (2) | Thrust piece | |
4 | Secure the differential on the mounting bracket and remove the screws (13) securing the crown (2) | Mark the crown (2) relative to the position on the satellite box housing (11). | |
Mount | |||
5 | Remove the crown (2) by slightly tapping its edge or end | Use a plastic hammer. | |
6 | Disassemble the satellite box (11) | Previously mark the position of the satellite box (11) against the cover | |
| Check | ||
7 | Wash the parts and check for damage and wear | If the self-locking screws are to be reused, clean their locking surface with a wire brush and remove any burrs from the seating surface of the satellite box. Replace the damaged and worn parts | |
Lubricate the parts when assembling | |||
| Assemble | ||
8 | Mount the satellite box housing (11) on the mounting bracket and mount the thrust washer (10) on the planetary gear (9) | Mount | |
9 | Mount the satellite gears (6), the split shaft of the spider (7) and the shaft (8) on the satellite box housing (11) | ||
10 | Mount the planetary gear (4) with the thrust washer (3) on the satellite gears (6) and crosspieces | ||
11 | Mount the crown (2) on the satellite box housing (11) | Note the identification position (mark) on the satellite box housing (11) against the assembly position of the crown (2). | |
12 | Install the screws (13) on the crown (2) | Rear axles 743.451/453/454/458/480Bevel gear on differential case | |
Rear axles 743.480Bevel gear on differential case | |||
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
13 | Heat the tapered roller bearings (1, 12) to approx. 80 °C and install them | Install the tapered roller bearings (1, 12) with no play. | |
14 | Install the differential on the rear axle |
| |
Puller |
314 589 00 63 00
Thrust element
337 589 02 31 00
Mount
000 589 89 33 00
Puller
360 589 02 63 00
Thrust piece
327 589 00 63 00
Thrust piece
Henviste dokumenter
- ar3530b0464f
- as0000z000201a Fare for personskade på hud og øjne ved håndtering af varme eller glødende genstande