1 | Drift |
2 | Assembly sleeve |
3 | Press-out sleeve |
4 | Rubber mount |
S35.25-4500-02
S35.25-4501-02
Danger | Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC) | Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines. | |
Warning | Risk of injury caused by elastomer bearings or bearing parts coming loose suddenly during installation/removal and shooting wildly through the air | Shield hazard area with suitable catch device (basket, iron-barred box). Also ensure that no unauthorized persons are present in the hazard area. | |
Topical note | General information on handling vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system | ||
| Remove | ||
1 | Remove rear axle semi-trailing arm | ||
To do this, only detach damper from semi-trailing arm. | |||
2 | Press out rubber mount (4) with drift (1) and press-out sleeve (3) | Removal and installation tool | |
| Check | ||
3 | Check bearing seat in semi-trailing arm for condition | Check for wear and expansion. Replace semi-trailing arm if necessary. | |
| Install | ||
4 | Clean bearing seat and coat with lubricant | Lubricant, rubber assembly 1 l | |
5 | Press in rubber mount (4) with insertion sleeve (2) and drift (1) | After pressing in, check the rubber mount (4) for correct seating. | |
Removal and installation tool | |||
6 | Install rear axle semi-trailing arm |
730 589 00 43 00
Removal and installation tool
Henviste dokumenter
- ah0000z030001a Generelle oplysninger ved køretøjer med højvoltsnet og/eller litium-ion-batteri og/eller gasdrivsystem samt personligt beskyttelsesudstyr
- ar3525s2200s Af-, påmontering af skråsvingarm bagaksel
- as0000z001401a Fare for personskade på grund af elastomerlejer eller lejedele, som pludseligt frigøres ved ud- og indpresningsprocessen og så flyver ukontrolleret omkring
- as0000z003501a Livsfare ved arbejde på komponenter og systemer med U >= 30 V vekselspænding (AC) eller U >= 60 V jævnspænding (DC)