ar3340w064601a

Shift sleeve end float (lateral differential lock) - checking and adjusting

Type ar · emne 33.40 · version 0101 · 2001-01-31

Gælder for: FRONT AXLE 730.100 /101 /102 /108 /109 /110

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 2 Chassis › 33 Foraksel › 33.40 Differentialespærringer

EinPAS 17 Drivstreng/aksel › 17.50 Foraksel › 17.50.38 Gearskifte

Gælder også for motorer/gearkasser: 730 100, 730 101, 730 102, 730 108, 730 109, 730 110

AR33.40-W-0646-01A

Shift sleeve end float (lateral differential lock) - checking and adjusting

Test specifications for shift sleeves for interaxle lock/differential lock

Number

Designation

Front axle 730.1

BE33.40-N-1002-01A

End float of shift sleeve for the final-drive unit's differential lock

mm

0.5

Shift sleeve end float (lateral differential lock) - checking and adjusting

W33.40-0005-01

Inspecting

1 Screw a M18 x 1.5 bolt (arrow) into the interaxle lock's hydraulic cylinder.

2 Use the bolt to tension the shift sleeve (1), continuing until the differential lock engages.

3 Use a feeler gauge to measure the end float between the tooth base of the engaged shift sleeve (1) and the tooth tip on the dog clutch (2).

Shift sleeve end float (lateral differential lock) - checking and adjusting

W33.40-0006-01

Adjusting

If the result is outside of specification, screw the adjustment bolt (3) in or out on the shift shaft to readjust the end float. Proceed by first removing the differential lock hydraulic cylinder and releasing the 6-point nut (4).