Remove/install elastomer bearing on transverse control arm

AR33.20-S-1452-01S

Remove/install elastomer bearing on transverse control arm

 Warning

Risk of injury. Rubber mounts and bearing parts can suddenly come loose during installation/removal and shoot wildly through the air.

Shield hazard area with suitable catch device (basket, iron-barred box). Also ensure that no unauthorized persons are present in the hazard area.

AS00.00-Z-0014-01A

Model

639

except code XZ1 (Model generation 1)

except code ZG2 (Permanent all-wheel drive)

Model

639

with code ZG2 (Permanent all-wheel drive)

Repair materials

Number

Designation

Order number

BR00.45-Z-1002-06A

Antifriction paste, rubber parts 2.5 kg, DBL 6867.00

A 000 989 01 60

1

 Mount pressing-out sleeve (3) and position transverse control arm in the workshop press.

 Commercially available tools
Workshop press

2

Press out bearing (4) from transverse control arm using  drift (1).

 Commercially available tools
Workshop press

3

Check bearing seat in transverse control arm for condition.

 Check bearing seat for wear and enlargement, replace transverse control arm if necessary.

4

Clean bearing seat and coat lightly with lubricant .

5

Position transverse control arm in workshop press and mount  insertion sleeve (2).

 Before pressing in, ensure the correct position of the bearing (4).
Commercially available tools
Workshop press

6

Press bearing (4) into the transverse control arm using  drift (1).

 After pressing in, check the bearing (4) for correct seating.
Commercially available tools
Workshop press