ar3320p044001h

Pressing out and attaching supporting joint at steering knuckle

Type ar · emne 33.20 · version 0201 · 2009-11-18

Gælder for: MODEL 240

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 2 Chassis › 33 Foraksel › 33.20 Hjulleje, nav — Serie 240

EinPAS 17 Drivstreng/aksel › 17.50 Foraksel › 17.50.42 akselspindel/hjulnav/hjulleje — Serie 240

AR33.20-P-0440-01H

Pressing out and attaching supporting joint at steering knuckle

Modification notes

14.9.06

Self-locking nut, supporting joint to steering knuckle

*BA33.20-P-1002-01H

Wheel location, hub

Number

Designation

Model
240

BA33.20-P-1002-01H

Self-locking nut, supporting joint to steering knuckle

Stage 1

Nm

80

Stage 2

°

90

Pressing out and attaching supporting joint at steering knuckle
Pressing out and attaching supporting joint at steering knuckle

163 589 03 43 00

Press

Front axle supporting joint puller

240 589 02 33 00

Pressing out and attaching supporting joint at steering knuckle

P33.20-2057-05

Pushing off

1 Remove nut (7a).

2 Pry supporting joint (7) out of steering knuckle (5) using puller (042) and press (044).

When doing so, hold the puller (042) and press (044) securely, otherwise the special tool will fall to the ground if the supporting joint (7) detaches suddenly.

Attaching

3 Clean cone on steering knuckle (5) and supporting joint (7).

The conical joint must be free of oil and grease.

4 Join supporting joint (7) and steering knuckle (5).

The guide pin (7s) must locate in the hole in the steering knuckle (5).

5 Replace self-locking nut (7a) and tighten .