Front axle | 730.100 in model 950, 952, 954 |
Driven front axle without through-drive | |
Front axle | 730.101 in model 950, 952, 954 |
Driven front axle without through-drive | |
Front axle | 730.108 in model 930, 932, 934, 950, 952, 954 |
Driven front axle without through-drive | |
Front axle | 730.109 in model 930, 932, 934, 950, 952, 954 |
Driven front axle without through-drive | |
Front axle | 730.114 in model 374, 930, 932, 934, 949, 950, 952 |
Driven front axle without through-drive | |
Front axle | 730.115 in model 930, 932, 934, 949, 950, 952 |
Driven front axle without through-drive |
Shown on front axle 730.100 |
1 | Compressed-air line |
2 | Connector (brake wear sensor) |
3 | Drag link |
4 | Pitman arm |
5 | Vent line |
6 | Spring U-bolt |
7 | Spring plate |
8 | Connector (rpm sensor) |
9 | Nuts |
10 | Plug (differential lock) |
11 | Compressed air line (differential lock) |
12 | Propeller shaft |
13 | Connector (temperature sensor) |
W33.10-0002-06
Danger | Risk of death caused by vehicle slipping or toppling off during lifting | Only lift vehicle at the lift support points specified by the vehicle manufacturer. | |
Topical note | Special instructions for lifting and supporting vehicle | ||
Topical note | Notes on self-locking nuts and bolts | ||
Notes on safety-relevant components | |||
Notes on compressed air connection systems | |||
| Remove/install | ||
1 | Raise vehicle and support at vehicle frame | ||
2 | Remove wheels from front axle | ||
3 | Detach compressed air lines (1) from brake cylinders and compressed air line (11) from differential lock | ||
4 | Detach bleed line (5) from differential housing | ||
5 | Disconnect plug (10) from differential lock | ||
6 | Disconnect plugs (8) from rpm sensors | ||
7 | Disconnect plugs (2) from brakepad wear sensors | ||
8 | Disconnect plug (13) from temperature sensor | ||
9 | Disconnect propeller shaft (12) from front axle | ||
Support propeller shaft (12). | |||
10 | Detach drag link (3) from steering arm (4) | The drag link (3) detaches suddenly when it is pushed off. | |
Model 374, 930, 932, 934, 950, 952, 954Nut, drag link to steering arm | |||
Model 949Nut, drag link to pitman arm/steering arm | |||
Puller | |||
11 | Raise front axle until leaf springs are relieved of load | ||
12 | Remove spring U-bolts (6) and spring plates (7) | Nut to spring shackle of front axle | |
13 | Lower front axle and pull out from under the vehicle | Installation: Lightly grease the mounting holes for the center bolts in the front axle. When raising the front axle, make sure that the center bolts are inserted into the mounting holes. | |
Long-life grease | |||
14 | Install in the reverse order |
625 589 00 35 00
Puller
Henviste dokumenter
- ah0000n000101a Oplysninger om selvlåsende bolte og møtrikker
- ah0000z001901a Oplysninger om sikkerhedsrelevante komponenter
- ah0018n000101a Oplysninger om trykluftstikforbindelsessystemer
- ah0060n010001b Bemærkning til hævning og opklodsning
- ar4010w1100a
- ar4110w0050a
- as0000z003201a Livsfare hvis køretøjet glider ned fra eller tipper på liften under løft