Remove/install bearing bushing at stabilizer bar

Modification notes

652 589 00 33 02

Threaded spindle

Removal and installation tool

Removal and installation tool

Hand pump

652 589 00 33 01

652 589 00 33 11

652 589 00 33 21

652 589 00 33 22

Hollow cylinder

652 589 00 33 23

Hydraulic hose (complete)

950 589 02 33 00

Removal and installation tool

950 589 01 33 00

Press-in/out tool

 When removing and installing the bearing bushings it must be ensured that the corresponding insertion and removal tool is used for the different bearing bushings dia..

Bearing bushing dia.  Insertion and removal tool

58 mm 652 589 00 33 01

60 mm 950 589 02 33 00

65 mm 652 589 00 33 02

75 mm 950 589 01 33 00

W32.35-0002-01

Removing

1  Screw the threaded sleeve (2) into the  hollow cylinder (1) and screw onto the bearing bushing with the  threaded spindle and suitable  thrust piece for pressing out at the bearing bushing.

2  Connect the hydraulic hose to the  hydraulic pump and  hollow cylinder (1) and pull out the bushing in the direction of the arrow

W32.35-1035-01

Install

3 Insert bearing bushing (4) and  thrust piece for pressing (6) into the  conical sleeve (5).

4  Attach hollow cylinder (1) and  conical sleeve (5) to the stabilizer bar and tighten with the  threaded spindle (7) and  hexagon nut (8).

 Always attach the conical sleeve (5) with the bearing bush (4) on the countersunk side of the stabilizer bar.

W32.35-0004-01

5 Connect hydraulic hose to the hydraulic pump and hollow cylinder (1) and draw in the bushing.

Through the cutout (arrow) in the conical sleeve (5) check whether the bearing bushing is pressed in fully.

W32.35-1042-01

6 After pressing in the bearing bushing (4) caulk this on each side 4 times towards the stabilizer lug (arrows).