Remove/install front stabilizer bar linkage

AR32.35-D-3330TS

Remove/install front stabilizer bar linkage

18.04.2019

Model

907, 910

Modification notes

17.04.2019

Nut, torsion bar linkage to stabilizer bar

BA32.35-N-1002-02TS

17.04.2019

Nut, torsion bar linkage to transverse control arm

Model 907

BA32.35-N-1003-02TS

17.04.2019

Nut, torsion bar linkage to suspension strut

Model 910

BA32.35-N-1004-02TS

Shown on model 907, left side of vehicle, front wheel removed

1

Stabilizer bar linkage

2

Nuts

Shown on model 910, left side of vehicle, front wheel removed

1

Stabilizer bar linkage

2

Nuts

 Danger

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

 Warning

Risk of injury caused by pinching or crushing when working on springs or spring bodies that are under tension

Use only approved tensioning devices; additionally screen off hazardous area if necessary. Check special tools for damage and proper operation (visual inspection). Wear protective gloves.

AS00.00-Z-0001-01A

Notes on repair work on suspension components

AH00.00-P-0100-01A

 

Remove/install

1

Remove each front wheel.

AR40.10-D-1100TS

2

Unscrew nuts (2) from torsion bar linkage (1).

Topical note

Notes on self-locking nuts and bolts

AH00.00-N-0001-01A

Note on calculation of tightening torque when using insertion or socket tools with various effective lengths

AH00.00-P-0015-01CW

 Model 907Nut, torsion bar linkage to transverse control arm

*BA32.35-N-1003-02TS

 Nut, torsion bar linkage to stabilizer bar

*BA32.35-N-1002-02TS

 Model 910Nut, torsion bar linkage to suspension strut

*BA32.35-N-1004-02TS

If the threaded pin on the ball head turns too,



counterhold the threaded pin.

3

Remove torsion bar linkage (1).


Note installation position of torsion bar linkage (1).
The torsion bar linkage (1) gap is only sufficient when in the correct installation position.



Check

4

Check ball heads and seal bellows of torsion bar linkage (1) for wear and damage.

If corresponding findings exist,



replace torsion bar linkage (1).

5

Install in the reverse order

 Front axle stabilizer bar

Number

Designation

Model 910

Model 907

BA32.35-N-1002-02TS

Nut, torsion bar linkage to stabilizer bar

Nm

109

106

 Front axle stabilizer bar

Number

Designation

Model 907

BA32.35-N-1003-02TS

Nut, torsion bar linkage to transverse control arm

Nm

106

 Front axle stabilizer bar

Number

Designation

Model 910

BA32.35-N-1004-02TS

Nut, torsion bar linkage to suspension strut

Nm

109