Remove/install actuator rod for level control system travel sensor

AR32.33-W-0027NA

Remove/install actuator rod for level control system travel sensor

17.01.2018

Model

967

Shown on front axle

1

Actuator rod

2

Actuating lever

3

Rotor

B27

Front axle position sensor

Shown on rear axle at right

1

Actuator rod

2

Actuating lever

3

Rotor

B24

Left drive axle position sensor

B25

Right drive axle position sensor

 Warning

Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.

Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts.

AS00.00-Z-0005-01A

 Danger

Risk of death from lowering vehicle when working between wheels and body. Risk of injury from pinching or crushing when working on the air suspension.

Testing and repair work between the wheel and wheel arch or in the wheel well should only be performed if the vehicle is secured using suitable support fixtures to prevent it from lowering.
Adjustment operations should only be performed from underneath the vehicle.
Use only suitable support fixtures to secure the vehicle frame or vehicle axles in order to prevent them from lowering.
If necessary, additionally use suitable support fixtures in order to prevent other moving vehicle parts that are in the working area from lowering, or use suitable retaining devices to prevent these parts from moving suddenly and without warning.
Secure areas with moving vehicle parts against unauthorized access.

AS32.22-Z-0001-01A



Remove

1

Switch on ignition

2

Lower the vehicle onto the stop buffers with the level control operating unit

3

Switch off ignition

4

Fully drain compressed-air system

5

Mark the position of the rotor (3) to the housing of front axle position sensor (B27) or left drive axle position sensor (B24) or right drive axle position sensor (B25)

6

Remove actuator rod (1)



Install

7

Install actuator rod (1)

 The marked position of the rotor (3) to the housing of front axle position sensor (B27) or left drive axle position sensor (B24) or right drive axle position sensor (B25) must match.

8

Start engine and completely fill compressed-air system at idle speed

9

Move vehicle to driving level using level control system operating unit

10

Switch off ignition