AR32.20-P-0200-01A | Clamping and unclamping front and rear springs | ||
Danger! | Risk of injury caused by pinching or crushing when working on springs or spring bodies that are under load | Use only approved tensioning devices; shield off hazard area if necessary. |
202 589 02 31 00
202 589 14 63 00
202 589 01 31 00
202 589 13 63 00
Tensioning device
Tensioning plates
Tensioning device
Tensioning plates
203 589 01 63 00
Tensioning plates
Tensioning device
203 589 01 31 00
211 589 03 63 00
Tensioning plates
171 589 03 63 00
Clamping plate
Model-specific assignment of tensioning device/clamping plates:
Front spring tensioning device
Model 171, 203, 209 203 589 01 31 00
Front spring tensioning device
Model 129, 140, 170, 202, 208, 210 202 589 01 31 00
Front spring clamping plates
Model 171, 203, 209 203 589 01 63 00
Model 171 171 589 03 63 00
Front spring clamping plates
Models 129, 170, 202, 203, 208, 209, 210 202 589 13 63 00
Front spring clamping plates
Model 140 202 589 14 63 00
Rear spring tensioning device
Model 129, 140, 170, 202, 203, 208, 209,
210, 171 202 589 02 31 00
Rear spring clamping plates model
140 up to 12.94 202 589 14 63 00
Rear spring clamping plates model
140 as of 01.95 202 589 13 63 00
Rear spring clamping plates
Models 129, 170, 202, 203, 208, 209, 210 202 589 13 63 00
Rear spring clamping plates
Model 171 211 589 03 63 00
P32.20-0200-01
1 Insert clamping plates on the spring at the top and bottom.
Insert the clamping plates so that as many spring coils as possible are pre-compressed (front spring 7 to 8 spring coils, rear spring 3 to 5 spring coils).
2 Rotate the recess clearances of the clamping plates towards the inside of the vehicle.
3 Insert tensioning device into the clamping plates and lock on the upper clamping plate.
The retaining lugs (arrow) must latch in the recesses in the upper clamping plate.
4 Clamp spring.
Do not use any impact wrench/driver in order to not damage the thread.
5 Mark the position of the clamping plates relative to the spring coil with oil chalk.
6 Unclamp spring.
P32.20-0212-01
Pay attention to correct seat of the rubber mount in the front end and of the spring coil runout in the impression of the transverse control arm (arrow).
Shown on front spring
P32.20-0213-01
The bore in the impression of the spring control arm must be exposed after unclamping.
As a check, scan the position of the spring using a wire of 3 mm dia.
Shown on rear spring
Henviste dokumenter
- as0000z000101a Fare for kvæstelse på grund af fastklemning og knusning ved arbejde på fjedre eller fjederlegemer, som er under forspænding