1 | Crossmember |
2 | Rear center section |
3 | Longitudinal member reinforcement |
4 | Longitudinal member reinforcement |
5 | Bolts |
6.1 | Nuts |
6.2 | Nuts |
7 | Screw |
P31.30-2038-06
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
Topical note | Notes on self-locking nuts and bolts | ||
| Remove | ||
1 | Switch off ignition and store transmitter key outside of transmission range (at least 2 m) | ||
2 | Remove load compartment side trims | ||
3 | Remove rear bumper | ||
4 | Disconnect trailer hitch wiring harness from trailer recognition control unit and from vehicle interior/trailer hitch electrical connection | ||
5 | Unfasten rubber retainers on rear muffler | ||
6 | Unscrew screws (5) and remove crossmember (1) | Helper required. | |
7 | Detach heat shield above rear muffler until nuts (6.1) of longitudinal member reinforcements (3, 4) are accessible | ||
8 | Unscrew nuts (6.1, 6.2) | ||
9 | Remove screws (7) | ||
10 | Remove longitudinal member reinforcements (3, 4) | ||
| Install | ||
11 | Insert longitudinal member reinforcements (3, 4) | ||
12 | Lightly screw on nuts (6.1, 6.2) by hand | ||
13 | Screw in screws (7) slightly by hand | ||
14 | Position crossmember (1) onto longitudinal member reinforcements (3, 4) and screw in screws (5) slightly by hand | Helper required. | |
15 | Align longitudinal member reinforcements (3, 4) and crossmember (1) so that they are free of tension | ||
16 | Tighten nuts (6.1, 6.2) | Nut, longitudinal member reinforcement for trailer hitch to body | |
17 | Tighten bolts (7) | Screw/bolt, longitudinal member reinforcement for trailer hitch to body | |
18 | Screw bolts (5) tight | Screw/bolt, trailer hitch to longitudinal member reinforcement | |
19 | Secure heat shield above rear muffler | ||
20 | Secure rubber retainers of rear muffler | ||
21 | Connect trailer hitch wiring harness to trailer recognition control unit and to vehicle interior/trailer hitch electrical connection | ||
22 | Install rear bumper | ||
23 | Install load compartment side trims | ||
| Check | ||
24 | Perform function test on ball neck and on light signals at trailer socket |
Henviste dokumenter
- ah0000n000101a Oplysninger om selvlåsende bolte og møtrikker
- ar3119p1400lwt
- ar6830p1185lwe
- ar8820p2200lws
- as0000z000201a Fare for personskade på hud og øjne ved håndtering af varme eller glødende genstande
- as0000z001701a Fare for personskade på grund af snitsår eller hudafskrabninger grundet skarpkantede køretøjsdele