ar3035w110201a

Store and transmit parameters for drive control (FR) control unit

Type ar · emne 30.35 · version 0101 · 2010-11-25

Gælder for: ENGINE 900.9 ENGINE 902.9 ENGINE 904.9 ENGINE 906.9 ENGINE 924.9 ENGINE 925.9 ENGINE 926.9 ENGINE 457.9 ENGINE 541.9 in MODEL 950, 952, 953, 954 ENGINE 542.9 in MODEL 950, 952, 954

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 1 Motor › 30 Regulering, hastighedsreguleringssystemer › 30.35 Køretøjsmotorregulering (FMR) — Serie 900 (modeller 9**) · Serie 902 (modeller 9**) · Serie 904 (modeller 9**) · Serie 906 (modeller 9**) · Serie 950 · Serie 952 · Serie 953 · Serie 954

EinPAS 15 Motor › 15.45 Motorstyring › 15.45.11 Styreenhed/relæ — Serie 900 (modeller 9**) · Serie 902 (modeller 9**) · Serie 904 (modeller 9**) · Serie 906 (modeller 9**) · Serie 950 · Serie 952 · Serie 953 · Serie 954

Gælder også for motorer/gearkasser: 457 9**, 541 9**, 542 9**, 924 9**, 925 9**, 926 9**

AR30.35-W-1102-01A

Store and transmit parameters for drive control (FR) control unit

Requirements:

The following conditions must be fulfilled to transmit the parameters stored in the drive control (FR) control unit:

Battery voltage 24 V...26 V.

It is essential that the power supply for the STAR DIAGNOSIS computer remains constant throughout the entire period.

During transfer it is allowed to

start any other application,

perform on-board-diagnosis,

run or start the engine and

disconnect the vehicle battery.

-----------------------------------------------------------------------------------------

If the stored parameters cannot be received due to failure of the drive control (FR) control unit, the parameters for the new drive control (FR) control unit must be taken from the vehicle documentation system and entered manually.

-----------------------------------------------------------------------------------------

Store parameters for drive control (FR) control unit

1 Switch on ignition.

2 Start Diagnosis Assistance System (DAS) and select category "truck".

3 Select "Automatic model series access" and confirm with button F2

4 Select "Control unit direct entry"

5 Select "Drive control (FR)".

6 Select "Control unit adaptations".

-----------------------------------------------------------------------------------------

7 Select "Control unit replacement".

8 Follow the instructions of the system.

The control unit parameters are transferred automatically to STAR DIAGNOSIS and saved temporarily.

9 Switch off ignition.

Leave STAR DIAGNOSIS connected.

-----------------------------------------------------------------------------------------

Transfer parameters and teach in drive control (FR) control unit

10 Switch on ignition.

11 Start parameter transfer using button "F2" in Star Diagnosis.

12 Follow the instructions of the system.

The parameters buffered in Star Diagnosis are transferred to the new drive control (FR) control unit.

13 Select "Control unit adaptations" in the control unit "FR drive control".

14 Select "teach-in process" and start the respective teach-in processes.

15 Follow the instructions of the system.