T27.35-0001-12
1 Hexagon head bolt M8 x 28
2 Washer
3 Connector plug
4 Washer
5 Sealing ring
6 Hexagon head bolt M8 x 35 (9 ea.)
7 Hexagon head bolt M8 x 45 (30 ea.)
8 Washer
9 Shift valve housing
10 Lug
11 Flat plug
12 CANNON socket
| Remove/install | ||
1 | Remove oil pan | ||
2 | Remove inductive sensor (turbine speed) | Installation: The distance of the inductive sensor need only be adjusted for a replaced or a new valve body housing. | |
3 | Unscrew connector plug (3) | ||
4 | Remove washer (4) and sealing ring (5) | Before unscrewing, remove dirt and dust from connector plug. | |
Installation: Check sealing ring and replace if necessary. | |||
5 | Unscrew CANNON socket (12) and slide into the transmission housing | Installation: Insert plug-in connection into housing cutout so that the guide lug on the CANNON socket faces towards the drive. | |
| |||
6 | Detach connector (10, 11) | Use a screwdriver to release from meshing on both sides. Installation: Insert flat plug from harness for 'drive' inductive sensor, observe guide lug. | |
7 | Slacken off hexagon head bolts (6) in recesses and hexagon head bolts (7) on sealing surface of valve body housing (9), but do not yet unscrew | - Make sure that the hexagon head bolts M8 are released. - When releasing the valve body housing oil may splash out, therefore wear eye protection. | |
Installation: Screw-in hexagon head bolts with shims and tighten alternately crosswise. | |||
| |||
8 | Secure valve body housing (9) against falling down | ||
9 | Remove hexagon head bolts (6, 7) and remove valve body housing (9) | Make sure that the cable connectors do not get caught up in the transmission or torn off. | |
10 | Install in the reverse order |
Shift valve housing
Number | Designation | Trans-mission 721.913 /914 /915 916 /917 | ||
BA27.35-N-1001-01D | Bolt, shift valve housing to transmission housing | M8X35 | Nm | 23 |
M8X45 | Nm | 23 | ||
Housing