D27.50-1162-09
2 | Screw (7 pcs.) | 3.1 | Impeller | 3.3 | Sealing ring | ||
3 | Oil pump | 3.2 | Housing | 4 | Torque converter housing |
Caution | Risk of injury to skin and eyes due to handling of transmission oil. Health risk caused by swallowing transmission oil | Wear protective gloves, protective clothing and safety glasses. | |
Notes on automatic transmission | |||
| Remove/install | ||
1 | Remove automatic transmission. | ||
2 | Remove transmission housing from torque converter housing (4). | ||
3 | Remove output unit. | ||
The output unit consists of the multiplate clutch K3, rear hollow shaft, rear planet carrier, output shaft and rear ring gear. | |||
4 | Remove drive unit. | ||
The drive unit consists of the drive shaft, multiplate clutch K2, front planet carrier, inner plate carrier, multiplate clutch K1 and multidisk brakeB3. | |||
5 | Remove bolts (2) . | Bolt, oil pump with multi-disk brake B1 to torque converter housing | |
6 | Remove oil pump (3). | | |
Removal: Mark installation position of oil pump (3). | |||
For this, screw two opposing screws (2) into the housing (3.2) and loosen the oil pump (3) using a suitable tool. | |||
Installation: Replace sealing ring (3.3). Observe marked installation position of oil pump (3). The chamfer (arrow) of the impeller (3.1) must face toward the housing (3.2). | |||
If the oil pump (3) is reused. | |||
| |||
Replace radial shaft sealing ring of oil pump (3). | |||
Remove/install oil pump radial shaft sealing ring | |||
If oil pump (3) is replaced. | |||
| |||
Install radial shaft sealing ring of parts kit in oil pump (3). | |||
Remove/install oil pump radial shaft sealing ring | |||
7 | Install in the reverse order |
Henviste dokumenter
- ah2719p000101nkb Oplysninger om automatgearkasse
- ah2719p000101nkb
- ar2710d0005tsr
- ar2740d0301tsr
- ar2750d0601tsr
- ar2750d0611tsr
- ar2750d0612tsr
- as0040z000101a Fare for personskade på hud og øjne ved håndtering af gearolie. Sundhedsfare ved indtagelse af gearolie