W26.60-1345-09
1 | Shift rod (with cutout) | 5 | Locking pawl | 9 | Spring | ||
2 | Pin | 6 | Retaining ring | 10 | Pressure pin | ||
3 | Shift shaft | 7 | Detent bushing | 11 | Clamping bolt | ||
4 | Shift finger | 8 | Spring |
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
| Disassemble/assemble | ||
1 | Remove shift mechanism | ||
2 | Detach locking pawl (5) from gearshift shaft (3) | ||
3 | Clamp gearshift shaft (3) of shift mechanism in vise | Use soft vise jaws. | |
4 | Use hot air blower to heat gearshift shaft (3) in area of rigging screw (11) | ||
5 | Remove tensioning screw (11) | Assembly: Clean thread and coat completely with thread locking compound. | |
Rigging screw to shift shaft | |||
Quick-acting adhesive, Loctite 270 | |||
6 | Pull thrust bolt (10) out of gearshift shaft (3) | ||
7 | Clamp thrust bolt (10) into vise | Use soft vise jaws. | |
8 | Remove retaining ring (6) and detent bushing (7) | Detent bushing (7) is spring-loaded. | |
Assembly: Install new retaining ring(6). | |||
9 | Remove springs (8, 9) and rigging screw (11) | ||
10 | Drive out pin (2) and remove shift rod (1) | Assembly: The cutout on the shift rod (1) must be installed rotated through 180° relative to the shift finger (4) (arrow). | |
11 | Assemble in the reverse order |
Henviste dokumenter
- ar2660g0001aca
- as0000z000201a Fare for personskade på hud og øjne ved håndtering af varme eller glødende genstande