T26.50-0003-05
1 Circlip
2 Compensating ring (2 halves)
3 Cylindrical roller bearing
4 Input shaft
5 Serrated washer
6 Flanged washer
7 Cylindrical roller bearing cage
| Disassemble | ||
1 | Remove drive shaft (1). | ||
2 | Remove cylindrical roller bearing cage (7) from drive shaft (4) | The cylindrical roller bearing cage may remain on the main shaft when removing the drive shaft. | |
3 | Pry securing washer (1) off drive shaft (4) with a screwdriver | ||
4 | Push compensating ring halves (2) out with a screwdriver and remove | ||
5 | Pull cylindrical roller bearing (3) from drive shaft (4) together with toothed lock washer (5) | | |
| |||
6 | Push flanged washer (6) from drive shaft (4) | The flanged washer (6) is part of the cylindrical roller bearing inner race. | |
7 | Clean all parts, check for wear and replace parts if necessary | ||
| Assemble | ||
Danger! | Risk of injury to skin and eyes caused by handling hot or glowing objects. | Wear safety gloves, protective clothing and safety glasses, if necessary. | |
8 | Place flanged washer (6), cylindrical roller bearing (3) and toothed lock washer (5) onto drive shaft (4) one after the other | Heat the cylindrical roller bearing (3), the toothed lock washer (5) and the flanged washer (6) to approx. 120 °C. | |
9 | Drive compensating ring halves (2) into the groove | ||
10 | Install circlip (1). | After fitting, peen collar of securing washer (1) over in 3 - 4 places. | |
11 | Place cylindrical roller bearing cage (7) in drive shaft (4) | ||
12 | Install drive shaft (1) |
000 589 90 33 00
Puller arm
Puller
000 589 89 33 00
Henviste dokumenter
- ar2650t4743b
- as0000z000201a Fare for personskade på hud og øjne ved håndtering af varme eller glødende genstande