Shown with power take-off 135-11b/1b and power take-off 135-11b/1c |
1 | Seal |
2 | Shim |
3 | Power take-off 2 |
4 | Seal |
5 | Threaded rod |
6 | Bearing housing with output flange |
7 | Nut |
8 | Hydraulic pump |
S3 | Power take-off 2 indicator switch |
W26.45-1353-06
Shown with power take-off 135-11b/2c |
1 | Seal |
2 | Shim |
3 | Power take-off 2 |
4 | Seal |
5 | Threaded rod |
7 | Nut |
8 | Hydraulic pump |
S3 | Power take-off 2 indicator switch |
W26.45-1354-06
| Notes on self-locking nuts and bolts | ||
| Notes on compressed air connection systems | ||
| Remove/install | ||
1 | Remove propeller shaft on bearing housing with output flange (6) | Only on power take-off without hydraulic pump. | |
Propeller shaft to power take-off | |||
2 | Disconnect electrical connector from power take-off 2 indicator switch (S3) | ||
3 | Detach compressed-air line | ||
4.1 | Remove bearing housing with output flange (6) | On power take-off without hydraulic pump | |
Collect oil which runs out in a suitable container. | |||
Installation: Clean sealing surfaces and replace seal (4). | |||
Nut, second power take-off to power take-off | |||
4.2 | Detach hydraulic pump (8) | On power take-off with hydraulic pump | |
Collect oil which runs out in a suitable container. | |||
Installation: Clean sealing surfaces and replace seal (4). | |||
5 | Remove power take-off 2 (3) and shim (2) | Collect oil which runs out in a suitable container. | |
Installation: Clean sealing surfaces and replace seal (1). | |||
6 | Install in the reverse order | ||
7 | Check transmission oil level, adjust to correct level if necessary | ||
| Model 963, 964 | ||
| Model 967 |
Henviste dokumenter
- ah0000n000101a Oplysninger om selvlåsende bolte og møtrikker
- ah0018n000101a Oplysninger om trykluftstikforbindelsessystemer
- ap2600w2601h Manuel gearkasse - olieskift
- ap2600w2601k Manuel gearkasse - olieskift
- ar2645w0002ea