Gælder for: Transmission 711.6 in model 636, 639 Transmission 716.6 in model 636 Transmission 716.6 in model 639 except code ZG2 (Permanent all-wheel drive)
Ikke tilgængelig på “da”; vises på Engelsk.
Placering
Funktionsgruppe 2 Chassis › 26 Manuel gearkasse › 26.45 Kraftudtag, kraftudtagsdrev — Serie 636 · Serie 639
EinPAS 17 Drivstreng/aksel › 17.45 Kraftudtag › 17.45.60 Aksel/tandhjul/synkronisering/flange — Serie 636 · Serie 639
Gælder også for motorer/gearkasser: 711 6**, 716 6**
AR26.45-S-0070-01SD
Remove/install output flange of output shaft
Transmission
711.6 in model 636, 639
Transmission
716.6 in model 636
Transmission
716.6 in model 639
except code ZG2 (Permanent all-wheel drive)
Gear set, shafts
Number
Designation
Transmission 711.680
BA26.50-N-1001-01D
Nut, output flange to main shaft
M12x1.5
Nm
-
M24x1.5
Stage 1
Nm
-
Stage 2
Nm
-
Stage 3
Nm
-
M26x1.5
Stage 1
Nm
200
Stage 2, loosen
Nm
-
Stage 3
Nm
160
Manual transmission
Number
Designation
Transmission 716.637 in model 639 Transmission 716.652 in model 636, 639
BA26.50-N-1004-01K
Clamping screw to output shaft
Nm
110
901 589 00 07 00
Pin wrench
000 589 65 33 00
Puller
355 589 00 33 00
Puller
Remove
1
Remove bolt (2) to output flange (1) or unscrew nut.
To do so, counterhold the output flange (1) using pin wrench.
S26.45-4504-01
2.1
TRANSMISSION 716.6 Attach puller to output flange (1) using bolts M10x60x1.
2.2
TRANSMISSION 711.6 Position puller with gripper on output flange (1).
3
Remove output flange (1).
4
TRANSMISSION 716.6 Detach puller .
Check
5
Check output flange (1) for signs of galling, replace output flange (1) if necessary.
S26.45-4505-01
Install
6
Mount output flange (1).
7
Screw in bolt (2) or screw on nut . TRANSMISSION 716.6 TRANSMISSION 711.6
To do so, counterhold the output flange (1) using pin wrench .
