ar2645g0009ada

Remove/install power take-off 2

Type ar · emne 26.45 · version 0100 · 2018-09-05

Gælder for: Transmission 715.316/356/366/376/386/536/537/538/539 in model 800 Power take-off 123

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 2 Chassis › 26 Manuel gearkasse › 26.45 Kraftudtag, kraftudtagsdrev — Serie 800

EinPAS 17 Drivstreng/aksel › 17.45 Kraftudtag › 17.45.30 Kraftudtag komplet — Serie 800

Gælder også for motorer/gearkasser: 715 316, 715 356, 715 366, 715 376, 715 386, 715 536, 715 537, 715 538, 715 539

AR26.45-G-0009ADA

Remove/install power take-off 2

30.08.2018

Transmission

715.316/356/366/376/386/536/537/538/539 in model 800

Power take-off 123

Remove/install power take-off 2

1

Seal

1.1

Seal (separated)

2

Shim

3

Shift housing

4

Seal

5

Stud bolt

6

Bearing housing (with output flange)

7

Nut

8

Hydraulic pump (without output flange)

9

Electrical connector

A

Separation point

S3

Power take-off 2 indicator switch

G26.45-3275-06

Caution

Risk of injury to skin and eyes due to handling of transmission oil. Health risk caused by swallowing transmission oil

Wear protective gloves, protective clothing and safety glasses.
Do not pour transmission oil into beverage bottles.

AS00.40-Z-0001-01A

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Notes on compressed air connection systems

AH00.18-N-0001-01A

Remove/install

1

Detach electrical connection (9).

2

Remove compressed-air line from shift housing (3).

3.1

Remove hydraulic pump (8).

On power take-off with hydraulic pump

AR26.45-G-0002ADB

Do not disconnect the hydraulic lines if possible.
Collect hydraulic fluid which flows out in a suitable vessel.

Installation: Clean sealing surfaces and replace seal (4).

Nut, hydraulic pump to power take-off

*BA26.45-N-1013-04B

3.2

Remove bearing housing (6).

For power take-off with output flange

Collect transmission oil which flows out in a suitable vessel.

Installation: Clean sealing surfaces and replace seal (4).

Nut, second power take-off to power take-off

*BA26.45-N-1016-04B

4

Remove shift housing (3) and shim (2).

Installation: Clean sealing surfaces.
Replace seal (1), separate at connecting point (arrows A) and fit seal (1.1).

5

Install in the reverse order.

6

Check transmission oil level, correct, if necessary.

AP26.00-G-2601OH

Power take-off

Number

Designation

Transmission 715 with PTO 123, 124

BA26.45-N-1013-04B

Nut, hydraulic pump to power take-off

Nm

70

Power take-off

Number

Designation

Transmission 715 with PTO 123, 124

BA26.45-N-1016-04B

Nut, second power take-off to power take-off

Nm

70

Henviste dokumenter