1 | Bearing cap |
2 | Compression spring |
3 | Retaining ring |
4 | Catch bolt |
6 | Needle roller bearing |
T26.60-0018-01
| Disassemble | ||
1 | Remove gearshift system | ||
2 | Clamp bearing cap (1) in a vise | Use aluminum soft vise jaws. | |
3 | Remove needle bearing (6) from bearing cap (1) | Internal extractor | |
Counter stay | |||
4 | Remove retaining ring (3) | ||
5 | Press out compression spring (2) and catch bolt (4) upwards using a screwdriver and remove | ||
6 | Unclamp bearing cap (1) from vise | ||
| Clean | ||
7 | Clean all parts | ||
| Check | ||
8 | Check all components for wear and condition | If there are problems | |
| |||
Replace affected component. | |||
| Assemble | ||
9 | Clamp bearing cap (1) in a vise | Use aluminum soft vise jaws. | |
10 | Install compression spring (2) and catch bolt (4) in bearing cap (1) | ||
11 | Install circlip (3) | ||
12 | Install needle bearing (6) flush in bearing cap (1) | Drift | |
13 | Unclamp bearing cap (1) from vise | ||
14 | Install gearshift system |
000 589 33 33 00
Counter stay
000 589 27 33 00
Internal extractor
403 589 05 15 00
Drift