AR22.10-W-1160C | Remove/install rear engine mount | 17.10.11 |
ENGINES 457.9 in MODEL 374, 375, 940, 942, 943, 944, 958
W22.10-1012-09
Left side of vehicle
1 Engine mount
2 Screw/bolts
3 Transmission carrier
7 Screw/bolt
8 Muffler bracket
4 Battery lines
5 Bracket
6 Nuts
W22.10-1013-09
Right side of vehicle
1 Engine mount
2 screw/bolts
9 Transmission carrier
10 Wiring harness
6 Nuts
7 Screw/bolts
W22.10-1011-11
1 Engine mount
11 screw/bolts
| Remove/install | ||
Danger! | Risk of injury caused by body parts being pinched or crushed as cab is tilted | Ensure that no one is within the tilting range of the cab as it is being tilted. Always tilt the cab all the way to the end position and secure with the safety strut. | |
1 | Tilt cab | Only for code (F02) Cab L (long) / Single Cab or code (F04) Cab L (long). | |
| Notes on tilting the cab | ||
2 | Remove step plate over transmission | Only on model 374, 944. | |
3 | Remove Operation steps and step plate on side on the right | Only for model 374, 944, if right engine mount (1) was removed. | |
4 | Support transmission from below | Transmission jack | |
5 | Remove screw/bolts (2) to transmission carriers (3, 9) | | |
6 | Lift transmission until transmission carrier (3, 9) is about 1 cm from engine mounts (1) | The transmission must hang freely without tipping. Do not damage detachable parts while lifting. | |
7 | Additionally support the transmission | Detachable parts can be damaged when tipped. | |
8 | Remove cable tie for wiring harness (10) on right engine mount (1) | Only if right engine mount (1) is removed. | |
9 | Remove cable tie for battery lines (4) on holder (5) | Only necessary if left engine mount (1) is removed. | |
10 | Remove screw/bolts (7) For engine mount (1) to be removed | | |
11 | Remove nuts (6) and bolts (11) at engine mount (1) to be removed | Counterhold screw/bolts (11) at engine mount (1). | |
Installation: For the left engine mount (1) align muffler (8) holder to bores for screw/bolts (7, 11) in the frame. | |||
| |||
| Notes on self-locking nuts and bolts | ||
12 | Take out engine mount (1) | Installation: Clean mounting surface of engine mount (1) on frame. | |
13 | Install in the reverse order |
Engine mounts, engine supports
Henviste dokumenter
- ah0000n000101a Oplysninger om selvlåsende bolte og møtrikker
- ah6080n000301a Oplysninger om tipning af førerhus
- as6080z000101a Fare for personskade ved fastklemning og knusning, når førerhuset tippes