Remove/install rear engine mount · ar2210p1160tw · Mercedes-Benz WIS

AR22.10-P-1160TW

Remove/install rear engine mount

17.10.11

ENGINES 112 in MODEL 211.080 /082 /280 /282

ENGINES 113 in MODEL 211.083 /283

ENGINES 272 in MODEL 211.087 /287 /092 /292

ENGINES 273 in MODEL 211.090 /290

P22.10-2191-12

Shows model 211.087

1 Engine crossmember

2 Screw/bolts

3 Screw/bolt

4 Nuts

5 Engine mount

6 screw/bolts

P22.10-2126-04

Shows model 211.083

1 Engine crossmember

2 screw/bolts

3 Screw/bolt

4 Nuts

5 Engine mount

7 Nut

 	Remove/install
	Notes on self-locking nuts and bolts	All models	AH00.00-N-0001-01A
1	Raise vehicle with vehicle lift		AR00.60-P-1000T
2	Remove lower engine compartment paneling	 Only rear part.	AR61.20-P-1105T
3	Remove exhaust shielding plate for propeller shaft behind the transfer case		*BA61.10-P-1005-01C
4	Support automatic transmission with assembly lift and transmission platform	Transmission plate for passenger cars and commercial vehicles gotis://A_25/35/49_02.0
		Transmission jack 2.0-7.0 t gotis://H_00.10_01.0
5.1	Detach rear engine mount (5) from rear engine crossmember (1); to do this, unscrew nuts (4)	Model 211.080 /082 /087 /090 /092 /280 /282 /287 /290 /292
			*BA22.10-P-1004-03A
5.2	Detach rear engine mount (5) at rear engine crossmember (1), to do so remove screw/bolts	Model 211.083 /283
			*BA22.10-P-1004-03A
6	Remove screw/bolts (2) and bolt (3), remove engine crossmember (1)	 Installation: The screw/bolts (2) and bolt (3) have to be screwed in by hand as far as possible and only tightened after lowering the assembly lift, so that the thread in the body is not destroyed.
			*BA22.10-P-1005-03A
7.1	Remove screw/bolts (6) and remove engine mount (5)	Model 211.080 /082 /087 /090 /092 /280 /282 /287 /290 /292  Observe environmental protection regulations for disposal of engine mounts. Dispose engine mounts into mixed scrap.
			*BA22.10-P-1003-03A
7.2	Remove nut (7) and bolt and remove engine mount (5)	Model 211.083 /283
			*BA22.10-P-1004-03A
8	Install in the reverse order

 Frame floor assembly

Number	Designation		Model 211


BA61.10-P-1005-01C	Self-tapping screw connecting front cross strut to frame floor	Nm	23

 Engine mount, engine support (engine side)

Number	Designation		Model 211 with 4-MATIC


BA22.10-P-1003-03A	Bolt/nut, rear engine mount to transmission	Nm	50
BA22.10-P-1004-03A	Rear engine mount For engine support	Nm	40
BA22.10-P-1005-03A	Rear engine support on body	Nm	50