ar1830d684002d

Disassemble, assemble oil-water heat exchanger

Type ar · emne 18.30 · version 0111 · 2006-02-02

Gælder for: ENGINE 904.904 in MODEL 670 ENGINE 904.908 /914 /923 /936 in MODEL 668, 670

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 1 Motor › 18 Motorsmøring, motoroliekøling › 18.30 Oliekøling — Serie 668 · Serie 670 · Serie 904 (modeller 904, 908, 914, 923, 936)

EinPAS 15 Motor › 15.20 Motorsmøresystem › 15.20.31 filter/køling/termostat/ventilator/beholder — Serie 668 · Serie 670 · Serie 904 (modeller 904, 908, 914, 923, 936)

AR18.30-D-6840-02D

Disassemble, assemble oil-water heat exchanger

Oil cooling system

Number

Designation

Engines
900.9, 902.9, 904.9, 906.9

BA18.30-N-1002-01C

Bolt, housing cover to oil-water heat exchanger

Nm

25

Disassemble, assemble oil-water heat exchanger

D18.30-0051-01

1 Unscrew bolt (1.1) at oil-water heat exchanger and take housing cover (1.2) off the heat exchanger (1.3).

Installation: When tightening the bolt (1.1), ensure that the housing cover (1.2) and the gasket (1.4) do not shift.
If possible, do not tighten bolt (1.1) fully until after fitting on the oil-water heat exchanger.

Pay attention to tightening torque.

2 Take gasket (1.4) out of the housing cover (1.2).

Installation: Replace gasket (1.4), note installation position.

3 Assemble in the reverse order.