ar1440b2008tb

Remove/install pressure reservoir at pump module of exhaust aftertreatment system

Type ar · emne 14.40 · version 0405 · 2019-11-08

Gælder for: Engine 457 in model 958.434/441/443/444/452/453/454 Engine 457.910 in model 958.431/433/451/471/472/478 Engine 457.911 in model 695.023/053 Engine 460.984 in model 934.### #R Engine 460.984 in model 934.### #S

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 1 Motor › 14 Udstødningsmanifold, motorbremse, udstødningsrenseanlæg › 14.40 Efterbehandling af udstødningsgas, AdBlue — Serie 460 (modeller 984) · Serie 695 (modeller 023, 053) · Serie 934 · Serie 958 (modeller 431, 433, 434, 441, 443, 444, 451, 452, 453, 454, 471, 472, 478)

EinPAS 15 Motor › 15.40 Udstødningssystem/udstødningsefterbehandling › 15.40.51 pumpe/doseringsenhed/dyse — Serie 460 (modeller 984) · Serie 695 (modeller 023, 053) · Serie 934 · Serie 958 (modeller 431, 433, 434, 441, 443, 444, 451, 452, 453, 454, 471, 472, 478)

Gælder også for motorer/gearkasser: 457 ***, 457 910, 457 911

AR14.40-B-2008TB

Remove/install pressure reservoir at pump module of exhaust aftertreatment system

16.10.2019

Engine

457 in model 958.434/441/443/444/452/453/454

Engine

457.910 in model 958.431/433/451/471/472/478

Engine

457.911 in model 695.023/053

Engine

460.984 in model 934.### #R

Engine

460.984 in model 934.### #S

Remove/install pressure reservoir at pump module of exhaust aftertreatment system

W14.40-1019-08

1

AdBlue pump module

4

Pressure accumulator

6

Valve

2

Coolant lines

5

Sealing ring

7

housing cover

3

Pressure accumulator housing

Remove

Warning

Risk of burn injuries and scalding when working at AdBlue lines and the components attached to them. Risk of injury to skin and eyes when handling AdBlue. Risk of poisoning caused by swallowing AdBlue

Pour AdBlue into suitable containers only. Wait until the pressure is released before starting any work on the exhaust aftertreatment system.

AS14.40-Z-0001-01A

1

Remove the valve protective cap (6)

2

Empty the pressure accumulator (4)

Press the valve (6) until the pressure accumulator (4) is fully empty.

3

Remove the pressure accumulator (4)

Install

4

Clean the housing cover (7), and the pressure accumulator housing (3). Check for damages.

Replace the pressure accumulator (4), if necessary.

5

Install the pressure accumulator (4)

Use the prescribed grease. Note that the product is used economically, otherwise it may cause damage to the SCR system.

ABS sensor grease

*BR00.45-Z-1019-06A

6

Inflate the pressure accumulator (4) with compressed air

.

AP14.40-B-1490TA

7

Check the leak-tightness of the housing cover (7)

Repair materials

Number

Designation

Order number

BR00.45-Z-1019-06A

ABS sensor grease

A 000 989 62 51 10

Henviste dokumenter