Engine | 651 in model 900 |
with code HK4 (Rear air conditioning, reinforced) | |
for 2nd refrigerant compressor | |
Engine | 651 in model 906 |
with code H08 (Roof-mounted air conditioning system, reinforced) | |
for 2nd refrigerant compressor | |
Engine | 651 in model 906 |
with code HK4 (Rear air conditioning, reinforced) | |
for 2nd refrigerant compressor |
D13.21-0005-09
1 | Guide pulley | 02 | Tensioner | 05 | Clamping bolts | ||
2 | Poly-V belt | 03 | Guide pins | Bild A | Assembly tool | ||
01 | Retaining clip | 04 | Turnbuckle |
Danger ! | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
| Remove | ||
1 | Lift/jack up vehicle | ||
2 | Lay clamp (01) on A/C compressor belt pulley and crankshaft belt pulley/vibration damper (arrows a) | Assembly tool | |
3 | Bring the clamp (02) into the correct position, then lay guide pin (03) and turnbuckle (04) on the clamp (01) | Clamping bolts (05) for the clamp (02) must be positioned over the guide pulley (1) and below the poly-V belt (2) (arrows b). | |
4 | Tighten down guide pin (03) on clamp (01) | ||
5 | Tighten turnbuckle (04) until the guide pulley (1) can turn freely | Ensure that the guide pin (01) and clamping bolts (05) are seated correctly. | |
6 | Remove screw/bolt for the guide pulley (1) and remove guide pulley (1) | ||
| Install | ||
7 | Put on guide pulley (1) and tighten down screw/bolt | Self-tapping screw, tensioner pulley to oil pan | |
8 | Unfasten turnbuckle (04) until the poly-V belt (2) lies on the guide pulley (1) and the clamping bolts (05) are free | Ensure correct seating of poly-V belt (2). | |
9 | Remove guide pin (03) and clamp (02) | ||
10 | Remove clamp (01) | ||
11 | Lower vehicle |
651 589 01 43 00
Assembly tool
Henviste dokumenter
- ar0060d1000h
- as0000z001001a Livsfare, hvis køretøjet glider ned fra eller tipper på liften.