AR09.41-W-2003C | Remove/install boost pressure/charge air temperature sensor | 29.3.06 |
ENGINE 457.9 in MODELS 374, 375, 940, 942, 943, 944, 958
W09.41-1032-06
Shown on model 944 with code (GS3) "Hydraulic" gearshift
1 Electrical connector
2 Hydraulic lines (only for code (GS3) "Hydraulic" gearshift and code (IY2) Hydraulic fluid as per sheet 345.0).
3 Sealing ring
B111 Charge air temperature and boost pressure combination sensor
| Remove/install | ||
1 | Switch off ignition | ||
Danger! | Risk of injury caused by being caught or pinched as cab is tilted | Ensure that no one is within tilting range of cab as it is being tilted. Always tilt cab all way to end position and secure with safety strut. | |
2 | Tilt cab | ||
| Notes on tilting the cab | ||
3 | Remove holder for hydraulic lines (2) at engine | Only for code (GS3) "Hydraulic" gearshift and code (IY2) Hydraulic fluid as per sheet 345.0 | |
Do not disconnect hydraulic lines (2) | |||
4 | Unlock and disconnect electrical connector (1) on charge air temperature and boost pressure combination sensor (B111) | Press hydraulic lines (2) to the side by detaching electrical connector (1); only for code (GS3) "Hydraulic" gearshift and code (IY2) Hydraulic fluid as per sheet 345.0. | |
5 | Remove the charge air temperature and boost pressure combination sensor (B111) | Installation: Clean sealing surfaces. Check sealing ring (3) for damage; replace charge air temperature and boost pressure combination sensor (B111). | |
| |||
6 | Install in the reverse order |
Charge air pipe/charge air cooling
Henviste dokumenter
- ah6080n000301a Oplysninger om tipning af førerhus
- as6080z000101a Fare for personskade ved fastklemning og knusning, når førerhuset tippes