AR09.41-B-1311TJ | Remove/install charge air pipe | 12.02.16 |
Cumbustion engine 924.9, 926.9 with Vehicle 958.0, 958.1, 958.2
W09.41-1039-09
1 Charge air tube (from charge air cooler to intake collector)
3 Turbocharger air hose, black
4 Clamp
6 Compressor air intake hose
7 O-ring
8 Clamp
9 Charge air collector
10 Screws
11 Screws
W09.41-1036-06
Shown Engine 926.9 with Code (MS4) BlueTec 4
1 Charge air tube (from air cooler to intake collector)
2 Electric wiring harness
3 Turbocharger air hose, black
4 Clamp
5 Screws
6 Compressor air intake hose
7 O-Ring
8 Clamp
9 Charge air collector
| Remove and install | ||
Danger! | Risk of injury by seizing or compression while tilting the cab | Do not enter and do not allow others to enter the area below the cab while it is tilting in either direction. Always tilt the cab to its final position and lock the cab by means of the safety device. | |
1 | Tilting the cab | ||
| Instructions on cab tilting | ||
2 | Remove antinoise encapsulation from chassis frame, upper right side | ||
Danger! | Risk of explosion by fuel inflammation, risk of poisoning by fuel inhalation and ingestion, and risk of injury by fuel contact with skin and eyes | It is forbidden to smoke, set fire, sparks or open flame. Only store fuel in appropriate and respectively identified containers. When handling fuel wear appropriate protective clothing and equipment. | |
3 | Remove fuel hoses and electric wiring from flame system for cold engine start | Only in vehicles with Code (M89) flame system for cold engine start (FLA). Collect drained fuel. | |
4 | Remove turbocharger air hose, black (3) from charge air tube (1) | | |
5 | Remove compressor (6) air intake hose from charge air tube (1) | Only in vehicles with Code (MS4) BlueTec 4 or with Code (MS5) BlueTec 5. | |
6.1 | Remove screws (10, 11) | Engine 924.9, | |
6.2 | Loosen screw (5) | Engine 926.9, | |
7 | Unfasten wiring harness (2) from charge air tube bracket (1) | ||
8 | Remove turbocharger tube (1) | Close charge air collector (9) opening. | |
Installation: Clean sealing surfaces and replace O-ring (7). | |||
9 | Install in reverse order |
Charge air pipe/charge air cooling