AR09.20-P-1320T | Removing/installing the mixing chamber | 16.12.08 |
ENGINE 646.951 in MODEL 211.004 except CODE (474) Particulate filter
ENGINE 646.961 in MODEL 211.006 /206 /606 except CODE (474) Particulate filter
P09.20-2049-09
1 Mixing chamber
2 Charge air hose
3 Sealing ring (charge air hose)
4 Securing clamp
8 Sealing ring
9 Sealing ring
10 Charge air distribution pipe
5 Retaining spring
6 Bolts
7 Bolt
| Removing/installing | ||
Danger! | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | When moving components, ensure that no body parts or limbs are within the operating range of moving parts. | |
1 | Open engine hood | ||
2 | Remove the cover from the charge air distribution pipe (10) | ||
| |||
3 | Disconnect electric cables which run past mixing chamber (1) | Tie straps which are separated when removing, must be fitted again at the same position when installing. | |
4 | Detach the charge air hose (2) at the mixing chamber (1) | Installation: Replace the sealing ring (3) and ensure the exact seat of the securing clamp (4). | |
5 | Remove retaining spring (5) | ||
6 | Unscrew bolts (6, 7) and remove the mixing chamber (1) from the charge air distribution pipe (10) | Installation: Clean sealing surfaces and install new sealing rings (8, 9). | |
7 | Install in reverse order |
Crankcase ventilation, cylinder head cover
Henviste dokumenter
- ar0120p501402a
- ar8840p1000t
- as0000z001101a Fare for personskade pga. fastklemning eller knusning af fingre ved af-, påmontering og indstillingsarbejde på motorhjelm og bagklap, døre, dæksler og soltag.