AR09.20-P-0080CV | Remove/install air duct housing | 25.3.09 |
ENGINE 272 in MODEL 204
ENGINE 272, 273 in MODEL 207
P09.00-2056-07
1 Hose
2 Centrifuge cover
3 Retaining clamp
4 Air duct housing
B2/5 Hot film mass air flow sensor
M16/6 Throttle valve actuator
A Clic clamp
4a Detent
4b Detent
5 Seal
| Remove/install | ||
1 | Remove air filter housing | ||
2 | Remove hot film mass air flow sensor (B2/5) | ||
3 | Detach the hose (1) at the centrifuge cover (2) | ||
4 | Detach retaining clamp (3) on electric wiring harness from air duct housing (4) | ||
5 | Push notch (4a) downwards and swing away air duct housing (4) below from throttle valve actuator (M16/6) | ||
6 | Raise notch (4b) and remove air duct housing (4) from throttle valve actuator (M16/6) | ||
7 | Detach hose (1) at air duct housing (4) | Only when replacing air duct housing (4). | |
8 | Check seals (5) and replace if necessary | ||
9 | Install in the reverse order |