P09.10-2080-06
Shown on ENGINE 646 in MODEL 203
1 Cylinder head cover
2 Intake air duct
3 Intake hose
4 Air filter housing
5 Front rubber mount
6 Rear rubber mount
B2/5 Hot film MAF sensor
B28/5 Pressure sensor downstream of air filter
| Remove/Install | ||
1 | Remove trim panel of cylinder head cover | ||
2 | Separate electrical connector at hot film mass air flow sensor (B2/5) | ||
3 | Disconnect electrical connector at pressure sensor downstream of air filter (B28/5) | ||
4.1 | Detach pressure differential sensor at air filter housing | Model 209 | |
Loosen clamp at molded hoses and undo bolt. | |||
5 | Disconnect intake air port (2) at hot film mass air flow sensor (B2/5) | ||
6 | Release intake hose (3) at air filter housing (4) and detach | ||
7 | Pull out the front air filter housing (4) from the brackets vertically in the upward direction | Installation: Check the front rubber mount (5) for wear, replace it if required. | |
Installation: Apply lubricant to front rubber mount (5). | |||
Lubricant | |||
8 | Pull air filter housing (4) out of rear rubber mount (6) in direction of travel | Installation: Check the rear rubber mount (6) for wear, replace it if required. | |
Installation: Apply lubricant to rear rubber mount (6). | |||
Lubricant | |||
9.1 | Detach hot film mass air flow sensor (B2/5) from air filter housing (4) | When replacing the air filter housing (4). | |
10.1 | Adapt the quantity mean value using STAR DIAGNOSIS | When replacing the hot film mass air flow sensor (B2/5) | |
STAR DIAGNOSIS diagnosis system | |||
11 | Install in the reverse order |
Repair materials
Number | Designation | Order number |
BR00.45-Z-1002-06A | Lubricating paste, rubber parts 2.5 kg, DB supply specification 6867.00 | A 000 989 01 60 |