AR07.15-W-1628B | Remove/install MR/PLD control unit | 14.6.96 |
ENGINE 541.9 in MODEL 950, 952, 953, 954
ENGINE 542.9 in MODEL 950, 952, 954
W07.15-0078-06
1 Spacer
2 Rubber shock absorber
3 Washer
4 Screw
5 Vehicle wiring harness connector
6 Connector of engine wiring harness
7 Fuel heat exchanger
A6 MR/PLD control unit
| Remove/Install | ||
1 | Switch off ignition | ||
2 | Remove bottom noise encapsulation | ||
3 | Detach fuel heat exchanger (7) at the EC/PLN control unit (A6) | Fuel lines remain connected at the fuel heat exchanger (7). | |
4 | Release and disconnect connector of vehicle wiring harness (5) at EC/PLN control unit (A6) | For this step push the locking element toward top (arrow) and release the connector of the vehicle wiring harness (5). | |
5 | Release and disconnect connector of engine wiring harness (6) at EC/PLN control unit (A6) | For this step swivel locking clamp toward bottom (arrow) and release the connector of the engine wiring harness (6). | |
6 | Take MR/PLD control unit (A6) off the crankcase | Installation: Observe installation position of spacers (1) and of rubber shock absorber (2). | |
| |||
7 | Install in the reverse order | ||
8 | Relearn transponder key and also replacement key | Only if the EC/PLN control unit (A6) was replaced. |
Diesel injection system with unit pumps (MR/PLD)
Henviste dokumenter
- ar4721w5621b Af-, og påmontering af brændstofvarmeveksler
- ar8057w0010c Programmering af transpondernøgle