Remove/install ME-SFT [ME] control unit

AR07.08-P-1000AK

Remove/install ME-SFT [ME] control unit

28.2.07

 

Remove/install



Notes on avoiding damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

1

Open engine hood

2.1

Store basic data from ME-SFI [ME] control unit (N3/10) temporarily in STAR DIAGNOSIS

When installing a new ME-SFT [ME] control unit (N3/10).

 Installation: Transmit basic data from intermediate storage to the new ME-SFI [ME] control unit (N3/10).



Connect up STAR DIAGNOSIS and read out fault memory

AD00.00-P-2000-04AK

3

Turn off ignition

4.1

Remove engine trim panel

Engine 266.980

AR01.10-P-2405BK

5

Unscrew bolt (2) from wiring harness bracket (1)



*BA07.08-P-1002-01D

6

Release engine wiring harness plug (4) and vehicle wiring harness plug (5) and pull out of the ME-SFT [ME] control unit (N3/10)

 Installation: Carefully attach the engine wiring harness plug (4) and the vehicle wiring harness plug (5) to the ME-SFT [ME] control unit (N3/10) and lock.

7

Remove bolts (3)



*BA07.08-P-1001-01D

8

Tilt the ME-SFT [ME] control unit (N3/10) up to the rear

9

Unhook the ME-SFT [ME] control unit (N3/10) from the brackets (6)

 Installation: Replace seal (7).

10

Install in the reverse order

11.1

Perform sensor rotor adaptation using STAR DIAGNOSIS

 Only when replacing.

 Menu guidance:

 Engine control unit

 Adaptations

 Learning processes

Number

Designation

Engine 266

BA07.08-P-1001-01D

Bolt, ME-SFI control unit to air filter housing

Nm

4

BA07.08-P-1002-01D

Bolt, bracket to control unit

Nm

16