ar0707s1453sh

Remove/install hot film mass air flow sensor

Type ar · emne 07.07 · version 0101 · 2009-04-22

Gælder for: ENGINE 272 in MODEL 636, 639

Ikke tilgængelig på “da”; vises på Engelsk.

Placering

Funktionsgruppe 1 Motor › 07 Blandingstilberedning › 07.07 Luftmængdemåler, luftmassemåler — Serie 636 · Serie 639

EinPAS 15 Motor › 15.45 Motorstyring › 15.45.12 Sensor/kontakt/ledningssæt — Serie 636 · Serie 639

Gælder også for motorer/gearkasser: 272 ***

AR07.07-S-1453SH

Remove/install hot film mass air flow sensor

21.4.09

ENGINE 272 in MODEL 636, 639

Remove/install hot film mass air flow sensor

S07.07-4506-05

1 Intake air duct

2 Electrical connector

3 Locks

4 Clamp on flap fitting

5 Gasket

B2/10 Hot film mass air flow sensor

Remove/install

Notes on avoiding damage through contamination and foreign objects

AH00.00-P-5000-01A

1

Remove air filter housing

AR09.10-S-1150S

2

Remove intake air duct (1) at mass air flow sensor hot film (B2/10)

3

Disconnect electrical connector (2)

4

Unlock hot film mass air flow sensor (B2/10)

To do this carefully pull locks (3) upwards to avoid damage. Do not damage grid net.

5

Tilt hot film mass air flow sensor (B2/10) to the rear and remove

Do not damage clamp on flap fitting (4).

Installation: Correctly engage clamp on flap fitting (4) to avoid malfunctions.

Checking

6

Check seal (5), replace if necessary.

7

Check locks (3) and clamp on flap fitting (4)

In case of damage the complete component must be replaced each time.

8

Install in the reverse order

Henviste dokumenter