Check basic position of camshafts

AR05.20-P-6010TS

Check basic position of camshafts

12.4.06

 

Remove/install

1

Remove air filter housing

AR09.10-P-1150TS

2

Remove Hall sensor on camshafts

AR15.10-P-2000TS



Checking

3

Rotate the engine at the center bolt on the crankshaft in the direction of rotation of the engine (arrow) to a 55° Crank angle before ignition TDC

 The 305° marking (represents a 55° crank angle before ignition TDC) on the belt pulley must be aligned with the guide edge on timing case cover (2).



*001589650900

4

Check basic position of camshafts

 The markings (3) on pulse wheel must stand in the middle in sensor holes. If necessary, set basic position of camshafts when removing/installing camshaft adjuster: 

Remove, install camshaft adjusters

Camshaft adjuster for intake camshaft

AR05.20-P-7201TS

Camshaft adjuster for exhaust camshaft

AR05.20-P-7201TT

5

Install in the reverse order

 Danger!

Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the running engine

Secure vehicle to prevent it from moving by itself.
Wear closed and snug-fitting work clothes.
Do not grasp hot or rotating parts.

AS00.00-Z-0005-01A

6

Carry out an engine test run and check the engine for leaks