1o | Upper section of upper drive belt cover |
1u | Lower section of upper drive belt cover |
2 | Lower toothed belt cover |
P05.10-2463-03
1o | Upper section of upper drive belt cover |
1s | Screw/bolt |
1u | Lower section of upper drive belt cover |
2 | Lower toothed belt cover |
8 | Engine support |
8s | Screw/bolt |
P05.10-2468-05
Danger ! | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Remove/install | ||
1 | Open engine hood | ||
2 | Remove cylinder head cover trim | ||
3 | Unclip coolant expansion reservoir and place with attached lines to one side | ||
4 | Unclip coolant line on upper support brace and set aside | ||
5 | Remove upper support brace | ||
6 | Remove bottom section of soundproofing | ||
7 | Attach engine hoist | ||
8 | Remove right engine mount | ||
9 | Remove screw/bolt (1s) | Bolt securing toothed belt cover | |
10 | Open retaining clamps for upper section of the upper toothed belt cover (1o) and fold up upper section of the upper toothed belt cover (1o) in direction of engine mount | ||
11 | Open holder clamps of the lower section of the upper toothed belt cover (1u) and remove toothed belt covers (1o, 1u) upwards | ||
12 | Open retaining clamps of the lower drive belt cover (2) and remove drive belt cover (2) upwards | ||
13 | Remove screw/bolts (8s) and detach engine support (8) for engine mount from cylinder head. | If necessary | |
Installation: Replace screw/bolts (8s) with new ones. | |||
Bolt, engine support to cylinder head | |||
14 | Install in the reverse order |
Henviste dokumenter
- ar0120p501402olb
- ar2210p1102nkb
- ar2210p1125nkb
- ar3310p0105nkb
- ar9430p5300nkb
- as0000z001101a Fare for personskade pga. fastklemning eller knusning af fingre ved af-, påmontering og indstillingsarbejde på motorhjelm og bagklap, døre, dæksler og soltag.