T03.30-0007-06
1 Bolt for attaching flywheel
2 Guide bearing
3 Flywheel
4 Guide drift
5 Internal extractor
6 Countersupport
7 Drift
| Removing, installing | ||
1.1 | Remove clutch | Transmission 714.669 | |
1.2 | Remove spring clutch (hydraulic damper) | Transmission 721.407/ 804 | |
1.3 | Remove transmission with torque converter | Transmission 721.916/ 917 | |
2 | Attach engine cranking device | For counterholding flywheel when pulling off guide bearing | |
| |||
3 | Remove two opposite bolts (1) attaching the flywheel and replace each with a guide drift (4) | Installation: - Lightly oil thread and head contact surface of securing bolts before installing. - First of all, tighten to specified torque and then tighten finally to specified tightening angle. | |
| |||
| |||
| |||
4 | Attach internal extractor (5) and countersupport (6) | | |
| |||
5 | Pull out guide bearing | Installation: Knock in guide bearing with drift. | |
| |||
The guide bearing can also be knocked out with a drift when the flywheel is removed. | |||
6 | Install in the reverse order |
Flywheel, driven plate, vibration damper, starter ring gear
Number | Designation | Engine 447 | Engine 447 | ||
BA03.30-N-1002-01J | Bolt of flywheel to crankshaft | 1st stage | Nm | 100 | 100 |
2nd stage | ° | 95 | 95 | ||
000 589 33 33 00
Internal extractor
Countersupport
Drift
Torque wrench
403 589 05 15 00
000 589 27 33 00
000 589 62 09 01
403 589 02 63 00
Drift
Cranking device
407 589 00 63 00