AR03.30-D-8002SF | Remove/install a flywheel | 19.5.09 |
ENGINE 642.896 in MODEL 906 with TRANSMISSION 711.685
ENGINE 642.992 in MODEL 906 with TRANSMISSION 711.660
D03.30-1125-11
Shown on engine 642.992
1 Flywheel
2 Bolt
3 Guide bearing
4 Retaining lock
| Remove/install | ||
1 | Remove clutch | ||
2 | Install retaining lock (4) | ||
3 | Remove bolts (2) | Installation: Replace bolts (2). | |
| |||
4 | Remove retaining lock (4) | | |
5 | Take off flywheel (1) | Installation: Observe correcting seating of flywheel (1). | |
| Checking | ||
6 | Check flywheel (1) for damage and friction surface for wear; replace flywheel (1) if necessary | ||
7 | Check guide bearing (3) for damage and wear; replace flywheel (1) if necessary | ||
8 | Install in the reverse order | ||
9 | Attach STAR DIAGNOSIS, read out fault memory, delete if necessary and perform sensor rotor adaptation in menu item Control unit adaptation | Only if the flywheel (1) has been replaced. | |
| Connect STAR DIAGNOSIS and read out fault memory |
Flywheel, drive plate, vibration damper, starter ring gear
Number | Designation | Engine | |||
BA03.30-N-1004-01S | Bolt, two-mass flywheel/drive plate to crankshaft | Stage 1 | Nm | 45 | |
Stage 2 | ° | 90 | |||
Retaining lock
112 589 03 40 00